[1]庞伟.酸性气藏深井产能试井方法[J].油气井测试,2018,27(02):67-72.[doi:10.19680/j.cnki.1004-4388.2018.02.011]
 PANG Wei.Deliverability test method for deep sour gas wells[J].Well Testing,2018,27(02):67-72.[doi:10.19680/j.cnki.1004-4388.2018.02.011]
点击复制

酸性气藏深井产能试井方法()
分享到:

《油气井测试》[ISSN:1006-6977/CN:61-1281/TN]

卷:
27
期数:
2018年02期
页码:
67-72
栏目:
出版日期:
2018-04-25

文章信息/Info

Title:
Deliverability test method for deep sour gas wells
文章编号:
1004-4388(2018)02-0067-06
作者:
庞伟
 中国石化石油工程技术研究院  北京  100101
Author(s):
 PANG Wei
 Sinopec Research Institute of Petroleum Engineering, Beijing 100101, China
关键词:
 酸性气藏深井产能试井压力恢复产能方程无阻流量稳定流动测试时间
Keywords:
 sour gas reservoir deep well deliverability test buildup deliverability equation openflow capacity steady flow test time
分类号:
TE353
DOI:
10.19680/j.cnki.1004-4388.2018.02.011
文献标志码:
B
摘要:
 针对酸性气藏深井产能试井测试风险大、测试时间短难以达到稳定流动影响测试结果准确性的难题,考虑关井后续流造成的压降,建立了耦合井筒流动与地层渗流的酸性气藏深井产能试井模型,通过Laplace变换和数值反演进行求解,根据压力恢复试井解释结果设计4个生产制度,模拟压力变化直到达到稳定流动,利用稳定流动对应的产量和压力点回归产能方程,形成产能试井新方法。结果表明,渗透率为0.21×10-3μm2的储层,气井达到稳定流动需要近1000 h,而采用该方法仅依靠1次压力恢复测试数据,通过模拟4个生产制度下的流动即可求取具有较高精度的气井产能方程和无阻流量。该方法对缩短酸性气藏深井产能试井测试周期,降低复杂事故,提高产能试井的准确性具有重要作用。
Abstract:
 Deliverability test for deep wells in sour gas reservoir involves high risks and short duration, making it impossible to realize steady flow, which finally impedes the accuracy of test result. With consideration to pressure drops induced by continuous flows after shutin, a deliverability test model coupled with wellbore flow and formation seepage was built for deep wells in sour gas reservoirs. This model was solved using the Laplace transform and numerical inversion. According to the interpretation results for buildup well test, four production systems were developed to simulate pressure changes till reaching the steady flow. Then, production and pressure points corresponding with the steady flow were used for regression of deliverability equation to generate a new deliverability test method. A gas well in reservoir with permeability of 021×10-3 μm2 may take almost 1000 h to reach steady flow; however, by using the new method, highaccuracy deliverability equation and openflow capacity of the gas well can be obtained by using only the data of one buildup test and through simulating the flows in four production systems. The new method is of great importance to minimize the time required for deliverability test for deep wells in sour gas reservoirs, reduce the complexities and enhance the accuracy of deliverability test.

相似文献/References:

[1]曹银萍,黄宇曦,于凯强,等. 基于ANSYS Workbench完井管柱流固耦合振动固有频率分析[J].油气井测试,2018,27(01):1.[doi:10.19680/j.cnki.1004-4388.2018.01.001]
 CAO Yinping,HUANG Yuxi,YU Kaiqiang,et al. Natural frequency analysis for fluidsolid coupling vibration of completion string based on ANSYS workbench[J].Well Testing,2018,27(02):1.[doi:10.19680/j.cnki.1004-4388.2018.01.001]
[2]高 超,艾 昆,高 辉,等. 基于施工压力曲线的综合滤失系数测试方法及压裂参数优化[J].油气井测试,2018,27(01):8.[doi:10.19680/j.cnki.1004-4388.2018.01.002]
 GAO Chao,AI Kun,GAO Hui,et al.Test method of total leak-off coefficient and optimization of fracturing parameters based on operation pressure curves[J].Well Testing,2018,27(02):8.[doi:10.19680/j.cnki.1004-4388.2018.01.002]
[3]周小林,高志华,张 冲.龙凤山气田大通径免钻桥塞分段压裂先导试验[J].油气井测试,2018,27(01):62.[doi:10.19680/j.cnki.1004-4388.2018.01.010]
 ZHOU Xiaolin,GAO Zhihua,ZHANG Chong. Pilot tests of staged fracturing involving largediameter drillfree bridge plugs in the Longfengshan gas field[J].Well Testing,2018,27(02):62.[doi:10.19680/j.cnki.1004-4388.2018.01.010]
[4]魏 聪,陈宝新,刘 敏,等. 基于反褶积技术的S气井不稳定试井解释[J].油气井测试,2018,27(01):73.[doi:10.19680/j.cnki.1004-4388.2018.01.012]
 WEI Cong,CHEN Baoxin,LIU Min,et al. Interpretation of pressure transient well testing data of S gas well based on deconvolution technique[J].Well Testing,2018,27(02):73.[doi:10.19680/j.cnki.1004-4388.2018.01.012]
[5]张中宝.塔河油田深抽杆式泵一体化管柱工艺[J].油气井测试,2018,27(02):27.[doi:10.19680/j.cnki.1004-4388.2018.02.005]
 ZHANG Zhongbao.Deep integrated rod pumping string applied in Tahe Oilfield[J].Well Testing,2018,27(02):27.[doi:10.19680/j.cnki.1004-4388.2018.02.005]
[6]李军贤.地层出砂井测试工艺优化[J].油气井测试,2018,27(02):47.[doi:10.19680/j.cnki.1004-4388.2018.02.008]
 LI Junxian.Optimization of testing techniques for wells with formation sand production[J].Well Testing,2018,27(02):47.[doi:10.19680/j.cnki.1004-4388.2018.02.008]
[7]田向东,康 露,杨 志,等.海上油气井快速诱喷测试技术[J].油气井测试,2018,27(02):41.[doi:10.19680/j.cnki.1004-4388.2018.02.007]
 TIAN Xiangdong,KANG Lu,YANG Zhi,et al.Fast testing of induced flows in offshore oil/gas wells[J].Well Testing,2018,27(02):41.[doi:10.19680/j.cnki.1004-4388.2018.02.007]
[8]张 毅,于丽敏,任勇强,等.一种新型可降解压裂封隔器坐封球[J].油气井测试,2018,27(02):53.[doi:10.19680/j.cnki.1004-4388.2018.02.009]
 ZHANG Yi,YU Limin,REN Yongqiang,et al.A new type of degradable setting ball for fracturing packers[J].Well Testing,2018,27(02):53.[doi:10.19680/j.cnki.1004-4388.2018.02.009]
[9]褚春波,郭 权,黄小云,等.有限元分析径向水力压裂裂缝扩展影响因素[J].油气井测试,2018,27(02):59.[doi:10.19680/j.cnki.1004-4388.2018.02.010]
 CHU Chunbo,GUO Quan,HUANG Xiaoyun,et al.Finiteelement analysis on influencing factors for propagation of fractures induced in radial jet hydraulic fracturing[J].Well Testing,2018,27(02):59.[doi:10.19680/j.cnki.1004-4388.2018.02.010]
[10]梁 斌,谭先红,焦松杰,等.东海低孔低渗气田气井压裂投产后“一点法”产能方程[J].油气井测试,2018,27(02):73.[doi:10.19680/j.cnki.1004-4388.2018.02.012]
 LIANG Bin,TAN Xianhong,JIAO Songjie,et al.“Singlepoint” productivity equation for fractured gas wells in lowporosity and lowpermeability reservoirs, East China Sea[J].Well Testing,2018,27(02):73.[doi:10.19680/j.cnki.1004-4388.2018.02.012]

更新日期/Last Update: 2018-06-21